谁能给个华为交换机s2300的telnet配置

刚拆封的交换机，里边没有设置过!

连接 console 口：

切换视图：sys

[Quidway]interface vlanif 1

[Quidway-Vlanif1]ip address 你的网段ip 你的掩码
设置ip:我的例子：ip address 192.168.0.200 255.255.255.0
上述设置很重要，搞不好绝对上不了！

设完ip后，用xp的cmd telnet 192.168.0.200得到下面画面：
***********************************************************
* All rights reserved (2005-2008) *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
* Notice: *
* This is a private communication system. *
* Unauthorized access or use may lead to prosecution. *
*******************************************************

Warning:Login password has not been set!

失去了跟主机的连接。

上面的信息说明，ip设置正确，只是telnet用户没有设置！下面设用户：

[Quidway]user-interface maximum-vty 5
[Quidway]user-interface vty 0 4
[Quidway-ui-vty0-4]shell
[Quidway-ui-vty0-4]protocol inbound telnet
[Quidway-ui-vty0-4]authentication-mode password
[Quidway-ui-vty0-4]set authentication password cipher huawei
[Quidway-ui-vty0-4]user privilege level 15
[Quidway-ui-vty0-4]idle-timeout 5

完成上面设置后：用xp的cmd telnet 192.168.0.200 结果出现下面画面，输入密码huawei，成功！

***********************************************************
* All rights reserved (2005-2008) *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
* Notice: *
* This is a private communication system. *
* Unauthorized access or use may lead to prosecution. *
***********************************************************

Login authentication

Password:

这样设置，交换机任何一个口都能上Telnet